Easy-Mount Rotors Tomy offers a wide selection of Easy-Mount Rotors for the Flexpin Bench-top centrifuges. These rotors install and remove with the turn of a knob and the selection covers most of the commonly used centrifuge labware.
Flex-Spin Drive The Flex-Spin Drive features a flexible motor shaft that equalizes minor imbalances without damaging the centrifuge or triggering the imbalance protection system. This allows excellent tolerance for minor difference in sample volumes.
Superior Imbalance Protection Tomy has developed a unique concept in imbalance protection based on the kinetic energy generated by the entire rotational system including the motor, rotor, buckets and adapters. This system, with its expanded inputs, is capable of detecting a severe imbalance within a few seconds after the centrifuge is started.
Higher Speeds for Microplates The TS-38LB rotor and B438-96 buckets spin four 96-well microplates at 4,200 rpm generating 3,100G - sufficient for microplate based ethanol extractions of DNA.
High-Speed Fixed Angle Rotor The TLA-11 Fixed Angle Rotor is a high-speed rotor that takes up to six 35 to 50 ml conical centrifuge tubes, and generates up to 9,600G. The maximum speeds will depend on the tube manufacturers' specifications.
Flat Tabletop No Chamber Gasket on the tabletop provides easy sample load.
1. Imbalance Detector
6. Overspeed Detector
2. Scatter Containing Lid System
7. Motor Overheat Detection
3. Rotor Identification System
8. Overcurrent Detection
4. Lid Interlock System
9. Circuit Detector
5. Lid Detector
The operation panel is easy to use and read.
Programmable memory stores are provided.
Speeds are programmable in RPM or g values.
Common Jog-Dial and digital display simplify the control panel. 3 Acceleration and Deceleration steps (LC-220/230)
1,000ml (250ml x 4 places)
1,200ml (15ml x 80 places)
Flex-Spin Drive System
Digital / 0 to 9,990rpm
300 to 9,000rpm
Setting Speed ±50rpm
Digial / 0 to 9,990G
10 to 9,600G (Less than 300G:Units of 10G, More than 300G:Units 100G)
MASTER-20M / MASTER-20PM are low concentration model (measurement range Brix 0.0 to 20.0%) of the MASTER-M / MASTER-PM. MASTER-20M / MASTER-20PM are the successor model to the conventional N-20E. Good for measurements of low concentration fruit juices, cutting oil, etc. The MASTER-M / PM series is a good alternative choice when the water ... more